Square to round

Square or rectangle to round, straight and centered to start. Switch on Offset or Pitch when the job needs it.

Square end

WidthAlong the 0° line (corners 1 to 4 on the front)

DepthSame as width for a square

Diameter

HeightSquare end's center to the round's center, along Z

Sizes are

Material

Lay out onMean, mid-wall (the default), rolls to size. OD or ID to mark that face

Weld gapRoot opening, straight across the weld. Half comes off each side so the fitting holds its size

PiecesSeams in the middle of the flat sides

Lines per cornerAcross each corner's quarter of the round

Part tagWritten into the DXF