Reducer lateral pattern

Any branch on any reducer: rolled, offset off center, leaning either way, with a cut end. Lay it out and check it in 3D, then send it to us: we'll build it, or check it and send you the pattern.

Reducer

Large end OD

Small end OD

LengthEnd to end, along the axis

Type

MaterialThickness sets the neutral line

Branch

Branch OD

AngleFrom the small-end direction. 45 leans to the small end, 90 is a tee, 135 leans to the large end

RollDegrees around the reducer from the 0° line

OffsetSlides the branch sideways off the reducer centerline. Positive goes toward higher roll

PositionLarge end to where the branch centerline meets the reducer OD

LengthReducer OD to the center of the branch end, on the centerline

Branch end

End cut angle0 is square to the branch

End cut facesDegrees around the branch. 0 faces the large end, 180 the small end

Layout

Reducer seam atDegrees from 0°. Blank puts it opposite the branch

Branch seam atDegrees around the branch. 0 faces the large end

Layout stations

Fit toleranceA miss this small is corrected automatically, and shown

Part tagWritten into the DXF