Rectangle to rectangle

Square or rectangle to square or rectangle, straight and centered to start. Switch on Offset, Pitch or Twist when the job needs it.

End 1

WidthAlong the 0° line

Depth

Width

Depth

HeightEnd 1's center to end 2's, along Z

Sizes are

Material

Lay out onMean, mid-wall (the default), rolls to size. OD or ID to mark that face

Weld gapRoot opening, straight across the weld. Half comes off each side so the fitting holds its size

Pieces

Seams atCorners at 4 pieces makes each side its own plate

Part tagWritten into the DXF