Cylinder miter

Pipe or rolled cylinder with each end cut at any angle. For a two-piece turn, cut each piece at half the turn: 45° each for a 90°.

Pipe

Made from

Pipe size

Wall

LengthOn the centerline, cut to cut

End A cutDegrees from square. 0 is square

End B cutDegrees from square

Lay out onOD (the default) for a wrap on the outside. ID to burn a pattern for the bore

Weld gapRoot opening, straight across the weld. Half comes off each side so the fitting holds its size

Template starts atDegrees from line 1. Blank starts at line 1

Lines around

Template stockSets the wrap stretch-out

Part tagWritten into the DXF